JobsEQ by Chmura Logo

Service Technician

B & I Contractors Inc

Location: Tampa, FL 33619
Type: Full-Time, Non-Remote
Posted on: August 1, 2021
This job is no longer available from the source.
Service Technician
B & I Contractors, Inc
47 reviews
Tampa, FL 33619
Full-time
B & I Contractors, Inc
47 reviews
Read what people are saying about working here.
Job details
Job Type
Full-time
Full Job Description ROLE SUMMARY:
Perform Initial start up, commissioning and repair of commercial air conditioning equipment including but not limited to air handlers, air cooled chillers, water cooled chillers, cooling towers, pumps, packaged rooftop, fans, and boilers.
JOB RESPONSIBILITIES:
Perform start up on all types of mechanical equipment including filter install, belt and coupling alignment, greasing, and performance evaluations including recording all temperatures, pressures, subcooling and superheat.
Trouble shoots service and repair as needed all types of mechanical equipment.
Be able to clearly and professionally communicate to customers any issues that are discovered during install and start up and or repairs that may be required.
Be able to communicate to the office any additional work or engineering issues that may be require an RFI or change orders.
Be able to give direction and oversee the actions of an apprentice if under your direct supervision.
Perform all of the required duties while adhering to the company safety policies and regulations.
MINIMUM REQUIREMENTS:
Have a solid understanding of air conditioning, heating and HVAC systems with a two (2) Technical College Degree or equivalent Trade School Diploma. Be competent in the proper installation and service practices for duct systems, DX piping systems, chilled water piping systems, thermal storage systems and building automation systems.
PHYSICAL REQUIREMENTS:
Must be able to see well (either naturally or with correction); use hands, fingers, arms and legs fully; lift up to 50 lbs., stoop, kneel, crouch and crawl; climb and balance on ladders and scaffolds; stand for long periods of time.
SAFETY AWARENESS:
Executes all tasks in a safe manner; utilizes safe work practices as appropriate. Will wear protective equipment when entering areas requiring same (Hard Hats, Work Boots, etc.)
Undergo DPAS training necessary for travel to worksites (if applicable).
Will train on OSHA 10, 30 as appropriate.
All industry standard trade hand tools, including open and closed wrenches, socket sets, electrical meters, refrigerant gauges and specialty tools. - Vacuum pump, welding set & recovery equipment to be supplied by the company.